气体增压泵正确选择考虑因素

气体增压泵工作压力和流量：气动增压泵和动力单元的工作压力参照驱动气压为0.48Mpa时泵输出压力和流量。如果泵的最大输出压力大于所需的工作压力，这就要考虑安全措施。对于最大输出压力。动力单元的选型与泵一致。气体增压泵：http://www.xinmingte.com/

Gas booster pump working pressure and flow: working pressure pneumatic booster pump and a power unit according to the driving pressure of 0.48Mpa pump output pressure and flow. If the maximum pump output pressure is greater than the required working pressure, it is necessary to consider the safety measures. For maximum output pressure. Consistent selection and pump power unit.

气体增压泵驱动气体的压力和流量：气动增压泵和动力单元在连续工作时使用的驱动气压不超过0.69Mpa，在间歇工作时可达到1.03Mpa。在最佳性能状态时气动泵的耗气量。

Pressure and flow rate of gas booster pump driving gas: pneumatic driven pressure booster pump and a power unit used in continuous operation shall not exceed 0.69Mpa, the intermittent work can reach 1.03Mpa. In the best performance state aerodynamic consumption of air pump.

气体增压泵输送液体介质：气动增压泵泵输送的液体介质是气动增压泵的选型中着重考虑的部分。液压部分的材质和液压密封圈是由输送的液体介质所决定的。泵可用油、水和大多数液体介质。标准泵的主要液压密封圈是丁橡胶和聚氨酯，单向阀座采用特氟龙密封。其它密封材料包括碳氟化合物和亚乙基丙烯，这些密封材料主要用于输送的特殊介质。请向工厂或当地的分销商咨询密封材料选型。

Gas booster pump for conveying liquid media: pneumatic liquid booster pump delivery pump is considered in the selection of pneumatic booster pump parts. The material and the hydraulic part of the sealing ring is determined by the liquid medium conveying. Pump available oil, water and most liquid medium. The main hydraulic pump sealing ring is standard chloroprene rubber and polyurethane, one-way valve seat with Teflon seal. Other sealing materials including fluorocarbon and ethylene propylene, the sealing material is mainly used for special medium conveying. Please refer to the factory or a local distributor for sealing material selection.

气体增压泵可接受的体积和重量对于某些的应用，气动增压泵和动力单元的外形尺寸和重量也要重点考虑。

相关标签：气体增压泵安装调试基本要点

当前位置：首页 >> 公司动态 >> 行业资讯发布时间： 2014-09-23
上一篇：气体增压泵流量与入口压力分析下一篇：气体增压泵零件使用注意事项