气体增压泵在使用中应注意以下几个问题

1.正确选型：1. The right selection:气体增压泵分为气体增压泵和气液增压泵两种，气体增压泵可以对空气、氮气、氧气、氢气等气体增压，如果为腐蚀性气体，如 H2S,SO2等气体，在选型时客户应主动说明。气液增压泵适用于水、液压油等液体增压，如腐蚀液体也需要特殊说明。正确选型是气体增压泵稳定运行的前提。Gas booster pump can be divided into two kinds of gas booster pump and gas-liquid booster pump, gas booster pump for gas pressurization, such as air, nitrogen, oxygen, hydrogen and, if for the corrosive gas, such as H2S, SO2 and other gases, the customer should take the initiative to say during the selection. Gas-liquid booster pump is suitable for water, oil and other liquid pressurization, such as corrosive liquid also need special instructions. Correct type selection is prerequisite of gas booster pump. 2.过滤要求：2. The filtering requirements:气体增压泵动力源为压缩空气，要求气源洁净，颗粒要求在5um以下，一般工厂气源比较脏，如果不经过滤直接接到泵上，长期使用，泵会长期积污，会导致单向阀失灵、密封圈磨损严重。Ask gas booster pump power supply for compressed air, air clean, granular requirements below 5 um, general plant air is dirty, if not filtered directly to the pump, use for a long time, the pump will be long-term pollution, causes a one-way valve failure, severe sealing ring wear. 3.安装要求：3. Installation requirements:安装时驱动气源最好使用PU风管，原因容易安装，操作方便，管内不会生锈，如果使用金属管，气体增压泵http://www.xinmingte.com/安装前最好用压缩空气吹扫，避免焊渣吹到换向阀内，将换向阀卡死。气体增压泵可以垂直安装或水平安装，在条件允许的情况下，最好垂直安装，垂直安装能延长密封件的使用寿命。Install the driver gas source is best to use the PU duct, the reason is easy to install, easy to operate, the tube will not rust, if using a metal tube, gas booster pump installation before had better use compressed air purge, avoid welding slag in the directional control valve, reversing valve card to death. Gas booster pump can be installed in a vertical or horizontal installation, in conditions allow, best installed vertically, vertical installation can prolong the service life of seals.

当前位置：首页 >> 公司动态 >> 行业资讯发布时间： 2014-08-30
上一篇：详细介绍如何选择气体增压泵的管子下一篇：爆破试验台：常用的胶管检验方法